T O P I C R E V I E W |
bse1963 |
Posted - February 03 2009 : 09:19:45 AM Hi,
I work in an architectural office and receive drawings from differant consultants.
I have created differant pagesetups for each firm.
i have used the Deletepagesetups.scr to rmove there setups, as the plotter name is not the same as ours.
i have used the Import Page Setup wizard, but have some questions about it.
1. can i only add one pagesetup at a time? because we plot full size sheets, Half size sheets and 11x17 sheets. I have page setups for all of them in the same file by company.
2. How can i Set Current one of the pagesetups Hurricane imports?current |
3 L A T E S T R E P L I E S (Newest First) |
Admin |
Posted - February 19 2009 : 11:27:01 AM quote: 2. How can i Set Current one of the pagesetups Hurricane imports?current
The only way I know to manipulate the selection of the pagesetups is through the -plot command, unless you have a lisp to do it (along with other things) (like my previous link showed).
You can use the -PLOT command to get to the first prompt, but your script must say NO to the Detailed plot config prompt.
Command: -plot Detailed plot configuration? [Yes/No] <No>: <-Just say no! Enter a layout name or <Model>: Enter a page setup name <>: <-Enter pagesetup you want to select Enter an output device name or <HP LaserJet 6P>: Write the plot to a file [Yes/No] <N>: Save changes to page setup [Yes/No]? <N> Y <-Save it Proceed with plot [Yes/No] <Y>: N <-Don't plot it (unless you want to) Command:
Hope that gets you closer?
Regards Bill |
bse1963 |
Posted - February 19 2009 : 10:43:57 AM Hi
The "Append" feature should work for adding in the addtional pagesetups.
but the i don't think the other part of your reply is what i was looking for.
what i have are pagesetups for an 11x17 printer, a full size (say 30x42 page) and a half size (say 15x21).
with these three liasted in the pagesetup dialog box in autocad i can select the 30x42 pagesetup and hit the "set currect" button so that when plotting (and i use the Sheet Set Manager a lot) i select what every drawings i want then select "publish to plotter and i get full size drawings with just a couple of mouse clicks, no opening and closing of the drawings.
for 11x17 or half size i select the drawings and then select "Publish with Dialog Box" and my pagesetups are right there to select.
|
Admin |
Posted - February 03 2009 : 2:22:20 PM Hi,
You might find the following post useful, http://www.74mph.com/forum/topic.asp?TOPIC_ID=59&SearchTerms=psetup
You can also use the Hurricane "append" feature to join your pagesetup script to itself, over and over again.
I hope that helps!
|